Audi Q3: Cover and Cushion, Separating
Cover and Cushion, Separating, Bench Seat
Special tools and workshop equipment required
- Upholstery Clip Pliers -VAG1634-
Removing
- Remove the rear bench seat. Refer to → Chapter "Bench Seat/Single Seat, Removing and Installing".
- Remove seat cover with seat cushion for the rear bench seat. Refer to → Chapter "Cover and Cushion, Removing and Installing, Bench Seat".
- Remove the seat cover -1- from the seat padding -2- as far as possible and cut the upholstery clips -3- using pliers.
- Remove the seat cover from the seat cushion.
Installing
Install in reverse order of removal.
Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Cover and Cushion, Sport Bench Seat".
Cover and Cushion, Separating, Backrest
Special tools and workshop equipment required
- Upholstery Clip Pliers -VAG1634-
Removing
- Remove the rear seat backrest. Refer to → Chapter "Rear Seat Backrest, Removing and Installing".
- Remove the backrest cover and backrest cushion from the rear seat backrest. Refer to → Chapter "Cover and Cushion, Removing and Installing, Backrest".
- Remove the backrest cover -1- from the backrest padding -2- as far as possible and cut the upholstery clips -3- using pliers.
Installing
Install in reverse order of removal.
Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Cover and Cushion, Backrest without a Pass-Through".
Special Tools
Special tools and workshop equipment required
- Backrest Panel Tool -3370-
- Trim Removal Wedge -3409-
- Upholstery Clip Pliers -VAG1634-
Edition: A005A001321 - FU - 12/10/2014 - JY1038875
READ NEXT:
General, Technical data
Identification
Brake PR Numbers
The PR number on the vehicle data label describes which
brake system is installed in the vehicle.
Example of a Vehicle Data Sticker:
A - Front Brakes (eSEE MORE:
Ignition key
Applies to: vehicles with ignition lock
Fig. 80 Steering column: ignition lock
Starting the engine
Press the brake pedal.
Insert the ignition key into the ignition lock.
Turn the key briefly to position 2. The ignition
key automatically returns to position 1. Do not
press the accelerator peda
Steering Column Electronics Control Module -J527-, Removing and Installing
Steering Column Electronics Control Module -J527-, Removing and
Installing, with Mechanical Ignition Lock
The Airbag Spiral Spring/Return Spring with Slip Ring -F138-
and the Steering Angle Sensor -G85- are integrated in the
Steering Column Electronics Control Module -J527-.
- If replac