Audi Q3: A/C System, General Information
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / A/C System, General Information
- Introduction
- A/C Technology Basic Principles
- Refrigerant Oil
- A/C System and Refrigerant R134a Safety Precautions
READ NEXT:
Introduction
The purpose of this repair manual is to provide service
advisors and technicians with the basic knowledge needed to
ensure professional and competent procedures.
Note
Only the careful s
A/C Technology Basic Principles
Physical Principles
The four known states of water also apply to air
conditioning system refrigerants.
1 - Gaseous (invisible)
2 - Vapor
3 - Liquid
4 - S
Refrigerant Oil
General Information
Caution
When handling refrigerant oil, pay attention to
local regulations.
Refrigerant oil mixes with the refrigerant (about 20-40%,
depending on compressor type aSEE MORE:
Opening and closing the hood
The hood is released from inside the vehicle.
Fig. 144 Footwell: release lever
Fig. 145 Unlocked hood: lever
Observe the safety precautions.
Make sure the wiper arms are not raised up from
the windshield. Otherwise the paint could be
damaged.
Opening the hood
With the door open, pull the lever
Drive Axle, Removing and Installing, Left Drive Axle with CV Joint, Inserted
with Inner Splines
Special tools and workshop equipment
required
Puller - Driveshaft -T10382-
Torque Wrench 1332 40-200Nm -VAG1332-
Slide Hammer Set -VW771-
Removing
- Loosen the drive axle threaded connection on the wheel side.
Refer to
→ Chapter "Drive Axle Threaded Connection, Loosenin
© 2019-2026 Copyright www.auq3.net | 0.0129
