Audi Q3: A/C Compressor
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / A/C Compressor
- Overview - A/C Compressor Power Unit
- Overview - Belt Pulley
- Overview - Belt Pulley, Valeo A/C Compressor
- A/C Compressor, Removing and Installing on Bracket
- Refrigerant Lines, Disconnecting and Connecting at A/C Compressor
- Belt Pulley, Removing and Installing
- Belt Pulley, Removing and Installing, Valeo A/C Compressor
READ NEXT:
Overview - A/C Compressor Power Unit
Overview - A/C Compressor Power Unit, 4-Cylinder Engine
1 - Ribbed Belt
Check for wear
Removing and installing. Refer to
→ Rep. Gr.13; Cylinder Block, Belt Pulley Side
Overview - Belt Pulley
Overview - Belt Pulley, Denso A/C Compressor, Version 1
Note
This type of belt pulley is installed on a "7 SEU 16" A/C
compressor.
1 - Bolt
20 Nm
Replacing
2&nb
Overview - Belt Pulley, Valeo A/C Compressor
1 - Bolt
17 Nm
Replacing
- The threaded bolt holes, into which the self-locking bolts or bolts
with locking compound were installed, must be cleaned (for example with SEE MORE:
Windshield wipers
Switching the windshield wipers on
Fig. 44 Lever: windshield wipers
Fig. 45 Lever: rear window wiper
Move the lever to the
corresponding position:
0 - Windshield wipers off
1 - Rain sensor/intermittent mode. The windshield
wipers switch on once the vehicle speed
exceeds approximately 2 mph (4 km
General Information
Before beginning balancing, the following requirements must
be fulfilled.
Tire inflation pressure must be OK.
The tire tread must not be worn down on one side and should
be at least 4 mm deep.
The tire must not have any flat spots.
It is not possible to balance a flat spot.
The ti
© 2019-2026 Copyright www.auq3.net | 0.0138
